System
Doesn't Indicate Low Tape Condition (VHS Version Only) |
| Under
normal operation, the Low Tape indicator light on the control panel will
light up when there is approximately thirty minutes of tape remaining. If
the tape being used doesn't match the tape speed parameter specified in
the Record Settings menu, the system is unable to determine the amount of
tape remaining and the Low Tape indicator light will not light up. |
| From
the Main-Menu select Record Settings |
Main-Menu |
| Set Time/Date |
| Titler |
| Messages |
| Record Settings |
| Display Settings |
| Interface Selection |
| Master Reset |
| Exit |
|
 |
| Select
Tape/Speed and set the value to match the type of tape being used. |
| Record
Settings |
| Recycle Rec |
| Rec-over Protect |
| Power-up Record |
| Alarm Rec Dwell |
| Tape/Speed |
| Exit |
|
| |
