 |
||
 |
||
|
||
Testing
900MHZ Internal Cable |
||||
| This test is performed to troubleshoot problems with remote activation of the 900MHZ Transmitter. | ||||
 |
|
Disconnect the blue (Trigger) wire and the red (Remote Activation) wire from the vault PCB. Using an ohmmeter, touch the red lead to the red wire of the internal 900mhz cable. |
||
 |
Touch the black lead to Pin 3 of the RF Antenna connector on the back of the vault. The ohmmeter should read between 4.1 - 4.3 ohms. If the reading is outside this range, the internal cable is bad. |
|||